806835 v1.00 12.20 G5 User guide
38
SECTION 4: User maintenance
4.3 Cleaning
!
To clean all taps, Command Centre and
ancillaries, wipe external surfaces with a gentle
cleaning agent or a damp cloth and then wipe
dry immediately with a clean, dry cloth.
Do not use strong, corrosive, spray or abrasive
cleaners.
Command Centres must never be located near
or cleaned with water jets.
For the Touch-Free Wave Tap:
Do not use abrasives to clean the sensor lenses
at the sides, top and rear of the Touch-Free
Wave Tap.
Do not use disinfectant sprays without wiping
dry afterwards.
This could cause permanent malfunction and
void warranty.
To Next Page
Loading...
