Why won't water dispense from my Zip Micro BC (error E13)?
If your Zip Water Dispenser displays error code E13, it means the command center does not detect a tap connected, and water will not dispense from the tap. Ensure the tap connector is correctly inserted into the side of the command center. If the issue continues, contact Zip service.
What does error E11 mean on a Zip Water Dispenser?
If your Zip Water Dispenser displays error code E11, try power cycling the unit. If the fault persists, contact Zip service.
Details the process for installing the tap, including hole cutting and hose connection.
Specifies required clearances and airflow for the command centre installation within a cupboard.
Illustrates the connection of hoses, power, and USB cables to the command centre.
Guides through the initial setup, filter flush, and power cycling of the appliance.
Explains how to dispense boiling and chilled water, including continuous flow modes.
Describes how to enable/disable energy saving mode and its effect on boiling temperature.
Provides instructions for replacing the water filter cartridge and performing a filter flush.
Details the inspection, cleaning, and refitting of the air inlet filter screen.
General| Brand | Zip |
|---|---|
| Model | Micro BC |
| Category | Water Dispenser |
| Language | English |
To Next Page