Zippity OCEANSIDE - Step 8: Square and Secure Posts; Step 8.1; Step 8.2 A; Step 8.2 B

WWW.ZIPPITY-OUTDOOR.COM
9
ASSEMBLY INSTRUCTIONS
ZP19024
9” diameter
36” deep
Hammer drill will be needed for this step
STEP 8: SQUARE AND SECURE POSTS
Square the unit in the space where you plan to install your shower. The diagonal distance
between your posts must be equal for your unit to be square.
STEP 8.1
Surface Mount install: 

concrete wedge anchors (NOT INCLUDED),
or similar sized lag screws (NOT INCLUDED) if

STEP 8.2A
Post Extension install: Mark the post




INCLUDED). Use support blocks to hold the
unit while the concrete cures.
STEP 8.2B
y
x
Note: If your concrete is not level, insert
galvanized steel washers under the lower
side of the Surface Mount unl it is level.
Then, secure with wedge anchors.