29
E09
The controller is in an
inclined position
The device is not placed on a flat
surface.
Move device to flat, stable surface, then
restart.
E10
Transient current protection
Incorrect installation of the driver. Contact manufacturer’s service.
Incorrectly mounted engine. Contact manufacturer’s service.
The transmission part of the
treadmill is blocked.
Contact manufacturer’s service.
E11
Voltage is too high Check if the AC power is above 270 VAT or it is
unstable. If so, stop using the treadmill and report it
malfunction.
E13
Communication error
between the meter and the
controller. The counter is
not receiving a signal from
the drive.
Damaged wires between the meter
and the controller.
Contact manufacturer’s service.
Incorrectly connected socket. Contact manufacturer’s service.
E14
Voltage is too low Check if the AC power is lower than 160VAC or it is
unstable. If so, please stop using the product and report
malfunction.
The device does not work No power Connect the device to a power source.
The safety key is out Insert the safety key.
Short circuit Contact manufacturer’s service.
The ON/OFF switch is not on Turn the device on.
The running belt does not
move smoothly
The running belt is not lubricated
enough
Lubricate the running belt as per the
manual.
The running belt is too tense Adjust and centre the running belt as per
the manual.
The running belt is skewed The running belt is too loose Adjust and centre the running belt as per
the manual.
The drive belt is too loose Contact the manufacturer’s service.
To Next Page
Loading...
