Zircon Leak Alert WiFi User Manual

Select your router, enter password
(if applicable) and press the “Next”
arrow. You may need to
wait several seconds for this step
to complete.
IMPORTANT: ROUTER RELIABILITY IS KEY. If your router is factory reset,
replaced, has its wireless password updated, or if a new configuration is entered,
the Leak Alert
™
WiFi water detector must be reconfigured to the router. While The
Detector will still emit an audio and visual alert, it will be unable to send email
notifications. The Detector will chirp when disconnected from the router.
Set-Up Screen 2: DEVICE
Enter a name for your Leak Alert
™
WiFi water detector and enter
your local time. If you have
multiple Detectors, we recommend
naming them with The Detectors’
intended locations (i.e. kitchen sink,
water heater) – not to exceed
32 characters.
Email notifications will contain
The Detector name and time stamp.
Check the box by “SEND LOG
EVERY 6 DAYS” to receive an
optional event log summary every
6 days. The log reports the last
20 notifications sent, as well as
anytime there was a lost connection
to the router, once it is reconnected.
Press the “Next” arrow on the lower
right side of the screen.
192.168.4.1
Office
Wi-Fi CONTACT DONE
SEND LOG EVERY 6 DAYS
DEVICE
1 2 3
03:29 PM
192.168.4.1
Choose Wi-Fi router
DEVICE CONTACT DONE
CBCI-799B-2.4
ZirconFrontConference
ZirconCentral
Show Characters
Zircon Front
Conference_Demo_Network
LPC
DOS_Ethernet1
3DMachineRoom
•
••••••••••
WPS
Wi-Fi
1 2 3
“Next” Arrow
“Next” Arrow
5

Zircon Leak Alert WiFi Specifications

General

Brand	Zircon
Model	Leak Alert WiFi
Category	Security Sensors
Language	English