To Next PageTo Next Page
Need help?Do you have a question about the ZKTeco BG1060L and is the answer not in the manual?
General| Type | Automatic Barrier |
|---|---|
| Protection Grade | IP54 |
| Frequency | 50/60Hz |
| Protection Level | IP54 |
| Noise Level | ≤60dB |
| Arm Length | 6m (Max) |
| Opening Speed | 1.5 to 6 seconds |
| Power Supply | AC 220V/110V ±10%, 50/60Hz |
| Housing Material | Powder Coated Steel |
| Barrier Length | 3m, 4m, 6m |
| Closing Time | 1.5 to 6 seconds |
| Humidity | ≤90% RH |
| Lifespan | ≥5 million times |
| Voltage | AC 220V/110V |
Precautions for installing the barrier on a flattened ground and ensuring proper grounding.
Procedure for routing cables through protective sleeves and cable trays.
Detailed steps for assembling the boom to the barrier gate chassis.
Wiring instructions for connecting an LPR camera to the barrier gate mainboard.
Instructions for connecting a UHF controller to the barrier gate mainboard.
Wiring for loop detector to enable anti-smash and auto-close functions.
Wiring instructions for connecting a VR10 radar sensor for anti-smash and auto-close.
Wiring procedure for infrared/photocell detector for anti-smash function.
Overview of mainboard parameter settings and key descriptions for configuration.
Step-by-step guide to navigate and adjust mainboard parameters using the control panel.
Detailed description of various parameters, their functions, and default values for different boom lengths.
Instructions for pairing new remote controls and deleting existing ones from the system.
Procedure to set the delay time for the barrier to automatically close after opening.
Detailed dimensional drawings and measurements of the boom barrier components.
Guide for adjusting the horizontal and vertical angles of the barrier boom for proper alignment.
Step-by-step instructions to change the barrier boom direction from left to right or vice versa.
Instructions for adjusting the spring tension to achieve the best balance for the barrier boom.
