To Next PageTo Next Page
Need help?Do you have a question about the ZKTeco BG1060R and is the answer not in the manual?
General| Type | Automatic Barrier |
|---|---|
| Housing Material | Steel |
| Barrier Arm Material | Aluminum Alloy |
| Motor Type | Brushless DC Motor |
| Working Temperature | -30°C to 70°C |
| Operating Temperature | -30°C to 70°C |
| Protection Grade | IP54 |
| Weight | 65kg |
| Protection Level | IP54 |
| Arm Length | Up to 6m |
| Arm Type | Straight Arm |
| Opening Time | 1.5 to 6 seconds |
| Power Supply | AC 220V ±10% 50/60Hz |
| Input | Dry Contact |
| Communication Interface | RS485 |
| Barrier Length | Up to 6m |
| Operating Time | 1.5 to 6 seconds |
| Input Voltage | AC 110V/220V |
Describes conventions for GUI elements like buttons and window names, e.g., <OK>, [New User].
Explains the meaning of various symbols used in the manual for warnings, information, and significance.
Key safety and preparatory steps before installation, including ground requirements.
Instructions for routing and protecting electrical cables during installation using sleeves.
Step-by-step guide for securely mounting the barrier boom arm to the main unit.
Wiring diagram and procedure for connecting an LPR camera to the barrier gate mainboard.
How to connect a UHF controller to the mainboard for access control integration.
Connecting a loop detector for anti-smash and auto-close functions to the mainboard.
Wiring guide for integrating the VR10 radar sensor for vehicle detection.
Instructions for connecting safety sensors like infrared or photocell detectors.
Overview of accessing and adjusting mainboard parameters using the interface.
Explanations of each adjustable parameter and its configurable settings for different models.
Procedures for pairing new remote controls and deleting existing ones from the system.
Configuring the time delay for automatic boom closing after it has been opened.
Key dimensions relevant to the mechanical adjustments of the barrier boom.
Adjusting the horizontal and vertical angles of the barrier boom for proper alignment.
Step-by-step guide to switch the boom installation direction from left to right or vice-versa.
How to adjust the spring tension for optimal balance and operation of the boom.
Solutions for power indicator not lighting up or being off despite normal AC input.
Diagnosing and fixing issues where the motor fails to run even with power on.
Addressing problems with remote control pairing, signal interference, or receiver damage.
Steps to fix the issue where the gate closes partially then bounces back to the open state.
