Zodiac ARCO ARCOMAX - Page 3

2
may cause an electric shock. Contact a qualied technician.
• Do not place anything on the robot or on the control box (except for the radio
control).
• Do not use the robot if any of its components are defecve or missing (pump,
turbine, screw, nut, cable, etc.).
• Do not shorten or extend the oang cable.
WARNINGS RELATED TO ELECTRICAL APPLIANCES
• The power supply to the appliance must be protected by a 30 mA Residual Current
Device (RCD), in accordance with standards in force in the country of installaon.
This circuit breaker must be tested before using the robot. Press test buon : the
circuit breaker must stop the current ; press buon again : it restarts the current. If
the operaon is not carried out according to these instrucons, the circuit breaker
is defecve. If the circuit breaker shuts o the power outside the test procedure, it
indicates that there is a current leakage which can cause an electric shock. In this
situaon, do not use the robot and contact the Aer Sales Service for assistance.
• The pump must be supplied by a residual current device with a nominal residual
operang current ≤30mA.
• This Class III electrical device (the robot) is supplied with an independent power
supply cabinet. The robot alone can only be used with the supplied control box.
• Do not use an extension cord to connect the appliance ; connect appliance to
appropriate socket.
• When the mains plug is connected to the electrical installaon, Under no
circumstances should you li, transport or turn over the robot.
• Before carrying out any operaons, check that :
- The voltage indicated on the appliance informaon plate corresponds to the mains
voltage.
- The power grid is adapted to the power requierments of the appliance, and is
grounded.
- The plug (where applicable) is suitable for the socket.
• In the event of abnormal operaon, or if the appliance emits an odour, stop it
immediately, disconnect the power supply and contact a professional.
• Before carrying out any maintenance or servicing on the appliance, ensure that it is
switched o, that it is completely disconnected from the power supply and that any
other equipment or accessories connected to the appliance are also disconnected
from the power supply.
• Do not disconnect and reconnect the appliance to the power supply during the
operaon.
• Do not pull on the power cable to disconnect it from the power supply.
• If the power cable is damaged, it should only be changed by the manufacturer, an
authorised representave or a repair shop.
• Do not service or maintain the unit with wet hands or if the unit is wet.
• Before connecng the device to the power source, check that the terminal block
or power outlet to which the device will be connected is in good condion and not
damaged or rusted.
• Do not drop the oang cable plug into water, it is not waterproof. Do not drop it on
the ground as this could damage it.
• In stormy weather, unplug the appliance to prevent it from suering lightning
damage.
EN