What to do if my Zodiac Water Filtration Systems displays 'disp to 0'?
If your Zodiac Water Filtration Systems displays 'disp to 0', it indicates a potential issue with the sensor cable or the BNC connector. Verify that the connection between the ORP sensor and the Chlor Perfect is not short-circuited. Specifically, check for any short circuits between the central core of the cable and its outer shielding.
General| Brand | Zodiac |
|---|---|
| Model | Chlor Perfect |
| Category | Swimming Pool Filter |
| Language | English |
Authorised personnel must use PPE for safe operation and maintenance procedures.
Appliance is for pools/spas; children require supervision; users with reduced capabilities need guidance.
Installation must meet local standards; non-user maintenance requires a qualified professional.
Do not self-repair; unauthorized parts/modifications void warranty.
Avoid chemicals near appliance; do not touch moving parts.
Appliance requires a 30mA RCD, direct connection, and correct voltage/grounding.
Disconnect power before access; avoid wet hands; check cord condition.
Do not recharge/dismantle batteries; avoid water immersion.
Appliance must be collected separately for recycling.
Lists and identifies all parts of the appliance and kits.
Details power supply, output, protection index, flow rates, and pressure limits.
Provides physical measurements and labels for appliance parts.
Emphasizes importance of correct water balance before appliance installation.
Explains the proportional injection logic and cycle timings.
Details correct positioning for the ORP sensor and injection points.
Provides step-by-step instructions for installing fixture collars and the sensor.
Outlines how to connect the appliance to the power supply and filtration system.
Explains the functions of the control box buttons and the master switch.
Lists essential checks to perform before commissioning the appliance.
Step-by-step guide for calibrating the ORP sensor.
Instructions for manually priming the peristaltic pump.
How to activate and use the Boost mode for increased chlorine levels.
Details how to access and navigate the appliance's settings menu.
Describes methods for adjusting the desired ORP set point.
Explains how to configure the duration of the Boost mode.
Details the OFA safety mechanism and its settings.
Information regarding the calibration menu options.
How filtering status affects operation and potential deactivation.
Procedure to restore the appliance to its factory default settings.
Step-by-step guide for replacing the peristaltic pump tube.
Procedures for preparing the appliance for seasonal storage.
Lists common appliance behaviors, their potential causes, and solutions.
Explains various display messages, possible causes, and corresponding solutions.
To Next Page
