Need help?Do you have a question about the Zodiac TRi PRO and is the answer not in the manual?
General| Brand | Zodiac |
|---|---|
| Model | TRi PRO |
| Category | Swimming Pool Filter |
| Language | English |
Prepare pool water balance before installing the TRI PRO module.
Steps to install the TRI PRO module onto the TRi power pack.
Detailed steps for installing the POD assembly onto the pipework.
Procedure for inserting and connecting pH and ACL sensors into the POD.
How to install the flow switch onto the POD assembly.
Connects the peristaltic pump to the one-way valve on the POD.
Explains how the TRI PRO module is detected by the power pack.
Guide for testing and priming the peristaltic pump.
Step-by-step guide for calibrating the pH sensor using buffer solutions.
How to adjust the target pH level for the pool water.
Configure settings based on pool volume for accurate dosing.
Step-by-step guide for calibrating the ACL (ORP) sensor.
Adjusting the target Active Chlorine Level (ACL) set point.
Indicates pool pH is too low, requiring manual check and calibration.
Indicates pool pH is too high, requiring manual check and calibration.
Signifies issues with pH regulation or pump operation.
Indicates low disinfectant level, suggesting pH or sensor issues.
Indicates high disinfectant level, suggesting pH or sensor issues.
Indicates prolonged chlorine production without reaching set point.
To Next Page