How to fix Zodiac CyclonX RC 4380 Swimming Pool Vacuum that does not stay on the pool bottom?
If your Zodiac Swimming Pool Vacuum cleaner isn't staying firmly on the pool bottom, it might be due to air trapped inside. Try repeating the immersion process as described in the manual. Alternatively, the filter may be full or dirty, in which case, simply clean it.
Why Zodiac CyclonX RC 4380 does not climb the pool walls?
If your Zodiac Swimming Pool Vacuum isn't climbing the pool walls, the filter might be full or dirty, so try cleaning it. Microscopic algae can also make the walls slippery, so perform shock chlorination and slightly reduce the pH. Remember to remove the cleaner during this treatment. Also, check the brushes for wear and replace them if necessary.
What to do if Zodiac Swimming Pool Vacuum does not move on start-up?
If your Zodiac Swimming Pool Vacuum is not performing any movements on start-up, check that the outlet to which the control box is connected is receiving power. Also, ensure that you have started a cleaning cycle and that the indicators are illuminated.
What to do if Zodiac CyclonX RC 4380 nozzles are blocked?
If the discharge nozzles or bottom plug holes of your Zodiac Swimming Pool Vacuum become blocked, stop the filter pump and start a new cleaning cycle. Position the control box halfway along the pool's length, following safety guidelines. If cleaning remains suboptimal, adjust the control box location and where the cleaner enters the pool.
What to do if my Zodiac Swimming Pool Vacuum LED is flashing?
If your Zodiac Swimming Pool Vacuum is flashing its LED, ensure it's properly connected to the control box by unplugging and reconnecting it. Also, inspect the brushes and tracks for obstructions like sand or cable, and remove any external elements. Confirm that the cleaner is started while immersed in water. Check the propeller for stones or hair. Clean or replace the filter if needed.
What to do if Zodiac CyclonX RC 4380 Swimming Pool Vacuum control box does not respond?
If the control box for your Zodiac Swimming Pool Vacuum isn't responding, unplug the power cord from the mains socket, wait 10 seconds, and then plug it back in.
How to prevent Zodiac Swimming Pool Vacuum cable from tangling?
To prevent the cable of your Zodiac Swimming Pool Vacuum from tangling, avoid unrolling the entire length of the cable into the pool. Place only the necessary length in the pool and keep the rest beside the pool.
Instructions on how to set up the cleaner and its components.
Instructions for safely connecting the cleaner's control box to the power supply.
How to start, select, and adjust cleaning cycles and time.
Common problems with the cleaner's operation and their potential causes.
Explains LED indicators and provides solutions for common alerts.
General| Type | Robotic |
|---|---|
| Pool Type | In-ground |
| Filtration | Easy-to-clean filter canister |
| Cable Length | 18 m |
| Weight | 9 kg |
| Warranty | 2 years |
| Power Supply | 100-240 V / 50-60 Hz |
| Pool Size | Up to 12 x 6 m |
| Pool Size (Rectangle) | Up to 12 x 6 m |
| Cleaning Area | Floor, walls, and waterline |
| Cleaning Cycle | 2.5 hours |
| Cycle Time | 2.5 hours |
| Filter Type | Cartridge filter |
| Robot Weight | 9 kg |
| Cleaning Coverage | Floor, walls, and waterline |
| Dimensions | 43 x 40 x 30 cm |
To Next Page