6
1.3 I Operang principle
The cleaner is independent of the ltraon system and can therefore operate autonomously. It just simply needs to be
connected to the mains power supply.
It nds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: oor, walls, water line or oor only). Debris is sucked in and stored in the cleaner's lter.
The cleaner can be used:
- Via the control box supplied with the cleaner,
- Or via a smartphone or a tablet compable with the iAquaLink™ applicaon (see "❸ Using the iAquaLink™ app (for
iQ models)").
3.5 metres Minimum
: Control box
: Trolley*
: Cleaner
: Floang cable
: Plug
: Power cord
: “iAquaLink™” remote
control *
(* Depending on the model)
1.4 I Pool preparaon
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properes:
Water temperature Between 10°C and 35°C
pH Between 6.8 and 7.6
Free chlorine < 3 mg/ l
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to opmise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
To Next Page
Loading...
Need help?
General
