Zodiac is a registered trademark of Zodiac Group Australia Pty Ltd
ABN 87 002 641 965
219 Woodpark Rd, Smitheld, NSW 2164 Australia
For more information visit www.zodiac.com.au
or call Customer Care 1800 688 552
RISK OF SUCTION HAZARD, WHICH IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY OR DEATH.
READ THIS GUIDE IN ITS ENTIRETY BEFORE INSTALLING AND OPERATING THE CLEANER. Do not block
the suction ttings in the pool, the suction opening on the cleaner, or the cleaner hoses with any part of your body.
Do not expose your hair, loose clothing, jewellery, etc, to any suction outlet ttings in the pool/ spa or on the cleaner.
For complete installation instructions, download the owner’s manual from the website www.zodiac.com.au or
call the Customer Service Centre 1800 688 562.
Start to orientate the return line (s) down towards the walls so the water is divided.
1
Example of a pool with 1 return line Example of a pool with 2 return lines
Cleaner Body
AD Flow Valve
Universal Weir Cu
Hose mesh
Hose Weight
Pool Pulse™
Hose Section
Wheel Deector
Quick Connector
Install the AD Flow valve into the skimmer box. The way you connect the AD ow valve varies depending on the type
of skimmer you have.
2
1st case: with Waterco skimmer box
Screw the AD Flow Valve connector
into the top of the Vac Plate.
2nd case: with Poolrite skimmer box
Screw the AD Flow Valve connector
into the bottom of the Vac plate.
3rd case: with other types of skimmer box
AD Flow valve
Universal Weir Cuff
Assemble the hose sections, starting from the skimmer box until you reach the furthest point of your pool and add
2 extra sections. Add the hose weight on the last hose section as per the drawing below.
Connect the hose to the valve in the skimmer box.
Submerge the whole hose under water until there is no air left in the hose.
3
H0386300 REV A
QUICK START GUIDE
TM
To Next Page
Need help?
General
