Zodiac is a registered trademark of Zodiac Group Australia Pty Ltd
ABN 87 002 641 965
219 Woodpark Rd, Smitheld, NSW 2164 Australia
For more information visit www.zodiac.com.au
or call Customer Care 1800 688 552
Keep the hose under water and attach the ring by inserting the end of the cleaner hose through the outer ring.
Then push the quick connector over the hose.
4
Then connect the Pool Pulse™ by pushing the connector onto the pipe until it clicks in place. Turn on the pool pump
to measure the suction ow.
For best performance the Pool Pulse™ needs
to read 2.5
Once this step is achieved, you can disconnect
the Pool Pulse™ from the leader hose.
5
NOTE:
If Pool Pulse™ reads less then 2.5, then increase AD Flow Valve setting at 3 to increase suction ow.
If the Pool Pulse™ reads more than 2.5, then decrease the AD Flow Valve setting at 1 to decrease suction ow.
Extremity of the hose
with Wheel Deflecor
and Quick Connector.
Pool
Pulse
®
While still keeping the hose under water, attach the hose to the cleaner head by pushing the connector onto the pipe
until it clicks in place. Allow the cleaner to drift to the bottom of the pool.
Turn the pool pump on again, and your Zodiac cleaner is ready for cleaning, leaving you with a sparkling pool.
6
To avoid any serious injury and before starting step 6, turn o the pool pump.
a. It is most important to disconnect the head of
the cleaner from the leader hose section when
you take the Zodiac cleaner out of the pool.
b. From time to time, ensure the diaphragm is free of debris
and / or dirt and rinse it with water. Simply disconnect the
top of the cleaner to access the diaphragm.
For care and maintenance
7
To Previous Page
Loading...
