● How to preset the start time of ice making
1, In standby mode, press "Timing" button to preset the start time of ice making. "Timing" light
on and display flash. The number displayed is the remaining time until the start of ice making
(in hours).
2, Press "+" and "-" to set the desired time. The set time flash for 3 times and disappears, the
unit enters the presetting state, and the "Timing" light keep on.
3, After setting, press "Timing" button again to cancel the setting, and the "Timing" light off.
● How to preset the end time of ice making
1, During ice maker working, press "Timing" button to preset the end time of ice making.
"Timing" light on. The number displayed is the remaining time until the end of ice making (in
hours).
2, Press "+" and "-" to set the desired time. The set time flash for 3 times and disappears, the
unit enters the presetting state, and the "Timing" light keep on.
3, After setting, press "Timing" button again to cancel the setting, and the "Timing" light off.
● How to use the cleaning function
In the standby mode, press the “cleaning” button for 3 seconds enter the cleaning mode. The
unit starts automatic cleaning for 30 minutes. Then it returns to standby mode.
During the ice making process, the ice maker will conduct a 35 second cleaning every 10 ice
making cycles. (Some models are different)
CLEANING AND CARE YOUR ICE MAKER
Please carry out maintenance according to the requirements of this manual, so as to
improve the efficiency of the ice maker and extend its service life.
Clean the environment around the ice maker frequently and keep it clean.
Do not block the ventilation louvers of the ice maker.
The outside of the ice maker should be cleaned regularly with a mild detergent solution
and warm water.
Clean the condenser once every three months. Use a soft brush or a vacuum cleaner
with a brush to brush the fins along the direction of the fins to prevent loss of fins.
The filter element of the water filter shall be replaced regularly. The ordinary filter element
needs to be replaced for half a year. For other filter elements, it should be replaced
according to its instructions. Or replace the water filter with a similar one (single stage
filter with 1/4-Inch quick connect). Remove the water filter connector as shown in the
To Next Page
Loading...