CONNECTING YOUR ICE MAKER
1. The water supplied to the ice maker must be passed the filter. Please do not directly
connected ice maker to tap water, poor water quality may cause ice maker failure.
2. The water supply pressure must be controlled at 130~550Kpa. If the pressure is too high,
a pressure reducing valve must be installed. Make sure to prevent the water inlet pipe
from being broken by high-pressure water pressure.
3. Connect the drain water pipe to the sewer. The ice maker drains by gravity, so it must be
ensured that the outlet of the drain pipe is higher than the inlet of the drain pipe.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
DANGER: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, it must be replaced by the manufacturer's
maintenance department or the like.
IMPORTANT:
1. For personal safety, the device should be properly grounded. The power cord of the
device is equipped with three-prong plug, which is matched with a standard three-prong
wall outlets to minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110-120 volt, 60Hz electrical outlet with three-prong
ground.
To Next Page
Loading...