Zonar Connect®
Installation/User Guide
Mounting & Operation - Cont.
3) Once mounting is securely installed, dock the Zonar Connect.
Wiring Installation
Refer to the cable guide (Fig. 3-1) for reference.
1) Disconnect vehicle battery (suggested).
2) Disconnect V3 4 Pin power.
3) Connect the Zonar Connect Power/Data cable to V3, the Zonar Connect dock, vehicle power and back-
up camera (if required).
Operation
Note: To learn how to operate the Zonar Confect’s applications and software, please refer to the User’s
Guide, Quick Start Guide or the built-in Help Documents specific to the application.
Operational Notes
1) The Zonar Connect requires a V3 to operate.
2) The Zonar Connect must be fully docked in order to send data to Zonar servers.
3) Sleep Modes:
A. The Zonar Connect enters sleep mode after 2 minutes of inactivity. This timeout can be adjusted to
30 seconds, 1 minute, 10 minutes or 30 minutes.
B. Power button ends sleep mode.
4) RFID Scanner’s optimal range is 0-1”.
5) Prolonged exposure to extreme temperatures can affect the Zonar Connect tablet’s performance. See
System Specifications.
To Next Page
Loading...