Zonar Connect - System Check: Minimum requirements; Verification Steps for Connection and Application Functionality

Zonar Connect®
Installation/User Guide
System Check: Minimum requirements
Note: If the terms and functions listed on this page are unfamiliar to you. Please refer to page 8
“prerequisites and reference material” for instructions on how to accomplish each step. We highly
recommend referring to the Zonar Connect “Quick Reference Guides”.
1) An installer must perform a full system check to verify the proper Zonar Connect connection
and operation
2) Start vehicle engine and ensure the following LEDs are:
A. Cellular - Solid - Green
B. GPS - Solid - Green or Orange
C. Status -Solid - Green
3) Power on the Zonar Connect and allow the device to boot up to the login screen:
A. ID: Scan driver card or manually enter driver ID
B. PIN: Manually enter PIN (Personal Identification Number)
4) Connect to WI-FI® (Highly suggested)
5) Ensure all purchased application(s) are present on the Zonar Connect. They may include one
or more of the following applications:
A. Zlogs - Hours of Service application
B. Navigation - Mapping and turn-by-turn direction application
C. Messaging - Two way communication between Asset and Dispatcher
d. EVIR® - Asset inspection application
6) Application checkout:
A. ZLogs® - Not required
B. Navigation - Open application, ensure map is oriented to your location. This ensures the V3
is properly passing Latitude / Longitude information to the Zonar Connect
C. Messaging - Ensure message can be sent:
1. From the Zonar Connect to Dispatcher - Ensure dispatcher can read the message
2. From Dispatcher to the Zonar Connect - Ensure message can be read on Zonar Connect
D. EVIR
1. Perform a full inspection using the Zonar Connect and RFID tags
2. Verify with dispatcher that inspection successfully uploads to Ground Traffic Control
after Zonar Connect is placed back into the dock.
7) Back-Up Camera (if equipped)
A. Apply vehicle brake(s)
B. Put transmission in “reverse”, and the Zonar Connect will switch over to rear camera view
C. Take transmission out of “reverse” and the Zonar Connect will revert back to computer
screen view