Need help?Do you have a question about the Zontes ZT155-Z2 and is the answer not in the manual?
General| Displacement | 155 cc |
|---|---|
| Transmission | 6-speed |
| Fuel System | Electronic Fuel Injection (EFI) |
| Front Suspension | Telescopic fork |
| Rear Suspension | Monoshock |
| Front Brake | Disc |
| Rear Brake | Disc |
| Fuel Capacity | 12 liters |
| Bore x Stroke | 58 mm x 58.7 mm |
| Starting System | Electric |
| Clutch | Wet multi-plate |
| Front Tire | 110/70-17 |
| Rear Tire | 130/70-17 |
| Ground Clearance | 160 mm |
| Engine Type | Single cylinder, 4-stroke |
| ABS | Dual Channel ABS |
| Frame Type | Steel |
| Wheelbase | 1, 370 mm |
| Weight | 128 kg (Dry) |
Procedures for main harness, dump switch, relay, and flasher.
Procedures for horn, shut down switch, and ignition coil.
Procedures for relay and ECU assembly/disassembly.
Procedures for flasher and rectifier removal.
Procedures for guard bar and water tank cover assembly.
Procedures for shroud bracket, hanging piece, and engine hanger.
Procedures for high-pressure oil pipe and throttle valve assembly.
Procedures for rear shock absorber removal and adjustment.
Procedures for rear wheel axle and sprocket bracket assembly.
Procedures for disassembling and changing rear disc brake pads.
Procedures for adding brake fluid to the rear brake master pump.
Procedures for draining oil, changing oil filter, and adding new oil.
Procedures for adjusting throttle and clutch cables.
Procedures for checking and adjusting steering shaft.
Procedures for adding brake fluid and replacing pads.
Procedures for tire, rim, and brake disc replacement.
Procedures for ABS hydraulic control unit and brake fluid release.
To Next Page
