Zoom 5590 - Page 9

9
2
22
2 The Zoom Configuration Manager opens and displays its
Basic Setup page.
Use this Web page to configure the modem so it can connect
with your Internet service provider. Do the following:
a
aa
a
Enter your Protocol, Encapsulation, VPI and VCI
settings in the appropriate boxes. If you do not know these
settings, refer to the tables on page 31 and look up your
service provider.
Tip!
If you refer to the tables and there is more than one listing
for your service provider, the most common is labeled (1),
the next (2), and so on.
NAT (Network Address Translation) is Enabled by
default. This feature lets multiple users access the Internet
sharing a single IP address.
Select Disable if users on your LAN have public IP
addresses and can access the Internet directly.
b
bb
b
Depending on the Encapsulation setting you selected, the
bottom half of the page will change so that you can enter
additional information.