5
4
44
4 Click Installation Wizard to start the software installation,
then click Next when prompted.
5
55
5 When the installation is complete, click Finish, then click
Exit.
6
66
6 Close any applications that may be open, then remove the CD
from the CD-ROM drive.
7
77
7 Shut down the computer.
Congratulations! You have installed the software. Now continue
with the next section, Installing the Hardware.
Step 2: Installing the Hardware
Be sure that you have already installed the software BEFORE
beginning this section.
1
11
1 Shut down your computer (if it is not shut down already). This
is the computer on which you just installed the software.
2
22
2 Rotate the antenna on the back of the modem to a vertical
position.
3
33
3 Connect the modem to the computer’s Ethernet port.
Plug one end of the Ethernet cable into any one of the
X6 modem’s LAN ports (LAN 1, LAN 2, LAN 3, or LAN 4)
and plug the other end into your computer’s Ethernet port.