29
Front and Back Panel
Descriptions
The front panel of the X6 looks like this:
The following table describes each light on the front panel.
Light Description
LAN
Lights when a LAN port of the X6 is plugged into the
Ethernet port of a powered-up device. Blinks when data is
sent.
WLAN
Lights when the wireless access point is running. Blinks
when data is sent.
LINK
Blinks when the X6 is performing its startup sequence.
Stays on solid when the unit has synched up with its
ADSL connection.
Note:
If the light fails to switch from blinking to steady
after a minute or two, check with your ADSL provider that
the ADSL connection is activated, or refer to Appendix D,
Troubleshooting
on page 22.
STATUS
Blinks red once while the X6 is powering up. Then, it will
only light when there is a problem with the unit.
PWR
Lights when the X6 is plugged into a power source.
To Next Page
Loading...
