Zoom G5 - Adjusting Z-Pedal Torque

39
Adjusting the Z-Pedal
2
To adjust the torque
You can use a 5mm hex key (Allen wrench) to adjust the vertical and
horizontal torque of the Z-Pedal.
To adjust the vertical torque
To adjust the horizontal torque
• Insert the hex key into the vertical torque adjustment screw on the side of the pedal.
Turn it clockwise to tighten the pedal, and turn it counterclockwise to loosen the pedal.
• Insert the hex key into the horizontal torque adjustment screw on the bottom of the pedal.
Turn it clockwise to tighten the pedal, and turn it counterclockwise to loosen the pedal.
NOTE
• Becarefulwhenlooseningatorqueadjustmentscrew,becauseifyouloosenittoomuch,itcouldcome
off inside the unit, making it impossible to hold the pedal in place.
Loosen Tighten
Loosen
Tighten