Operating the Zoom
H1
Handy Recorder
for Message Banking
1. Turning the Zoom H1 on and off …………………………
2. Recording a Message ……..………………………………
3. Playing a Recorded Message …………...…..................
4. Moving to the Previous/Next Recorded Message ……
5. Adjusting the Play Volume ………………………………..
6. Deleting One Recorded Message ..……………………..
7. Deleting All Recorded Messages ………………………..
1. Turning the Zoom H1 On and Off
To turn on the Zoom H1:
On the right side of the Zoom H1, slide
the Power switch all the way to the left.
Hold the Power switch to the left for about
1 second, then release.
The switch will return to the middle.
The screen will light up to say Hi followed by Card
Access.
When it is fully on, you will see a screen like this.
If the Zoom H1 does not turn on, either you did not hold the
power switch to the left for long enough or the battery is dead.
A Zoom H1 Handy Recorder is used during the recording phase of
message banking to capture phrases in your own speech that you want
to include in your message bank.
If your speech deteriorates in the future and you wish to use your
phrases as part of your communication system, you would not play
them out on the Zoom H1. Rather, the messages would be uploaded
onto an electronic communication device such as a smart tablet with a
suitable communication app/software.
Your speech and language therapist (SLT) or assistive technology (AT)
service will help you with this future step as needed.
To Next Page
Need help?
General
