Chapter 2 Using the Faxmodem 15
Using AT commands in terminal mode
1. Start your data communications program.
2. Change to terminal mode (also called command, local,
direct, or dumb mode).
3. Type in the AT command you need and press Enter.
When you finish, you can return to the data communica-
tions program’s standard user interface. See the program’s
documentation if you need help.
Returning to the Factory Settings
To return to the factory default settings for the modem:
In terminal mode, type AT &F and press Enter.
See the Web site at www.modems.com.
To Next Page
Loading...
