❒ Rack Mounting
This product conforms to EIA and DIN specifications for 19-inch rack mounting. We recommend to
mount the unit in a rack rather than just placing it on a table or similar. As shown in the illustration,
fasten the unit securely in the rack, using the four screw holes.
• This unit uses a metal enclosure and is heavier than it might seem at first glance.
When mounting in a rack, firmly support the unit and do not let go until all
screws have been fastened. If the unit is not secured properly, it can fall and cause
damage and injury.
• Do not stack the unit directly on top of other components. Otherwise overheating
poses a risk of fire and can lead to performance degradation.
• Before moving the unit, disconnect the AC adapter and all other cables.
Otherwise cables or equipment may be damaged.
• Use a sturdy rack and place it on a level, solid surface where there is no danger of
the rack vibrating or falling. Otherwise injury to persons or damage to equipment
may occur.
■ 2 ■
INPUT
PEAK
DIGITAL REVERB & MULTI EFFECTS
MIX
OUTPUT
VARIATION ADJUST
DRY WET
6
7
8
9
10
11
5
4
3
2
1
EFFECTS
DIMENSION
PERCUSSION
ENSEMBLE
POWER
GATE
REVERSE
AMBIENCE
VOCAL
PLATE
ROOM
HALL
6
7
8
9
10
11
5
4
3
2
1
BANK
A B C
MADE IN JAPAN
11
1
DELAY
CHORUS
FLANGER CHO/REV FLG/REV DLY/REV DLY+FLG CHO+DLY DLY+REV CHO+REV FLG+REV
2
3
4
5
6
7
8910
PITCH
PHASER
TRM-PAN
PIT-DLY
AUTO-FILTER
RING-MOD
Lo-Fi EFX
Vo-DIST ROTARY
VOCODER
KARAOKE
CHARACTER
REV TIME
REVERB
1
DELAY
CHORUS
FLANGER CHO/REV FLG/REV DLY/REV DLY+FLG CHO+DLY DLY+REV CHO+REV FLG+REV
2
3
4
5
6
7
8910
PITCH
PHASER
TRM-PAN
PIT-DLY
AUTO-FILTER
RING-MOD
Lo-Fi EFX
Vo-DIST ROTARY
VOCODER
KARAOKE
MADE IN JAPAN
To Next Page
Loading...
Need help?
General
