To Next PageTo Next PageWhy are my Zoom player 3000 patches not switching?
If your Zoom Computer Hardware patches are not switching, the device might be in Store standby status or standby status. Press the STORE key to execute the operation, or press the EDIT key to leave the standby status and return to Play mode.
What to do if volume turned down with RP01 (option) foot pedal on Zoom player 3000?
If the volume is turned down because of the RP01 foot pedal, operate the RP01 foot pedal to adjust the volume on your Zoom Computer Hardware.
What to do if my Zoom Computer Hardware effect monitor LED is off (flashing)?
If the Effect Monitor LED is off or flashing, press the pedal switch on your Zoom Computer Hardware so that the LED turns on (lit).
What to do if my Zoom player 3000 has no sound or extremely small sound?
If you are experiencing no sound or extremely small sound with your Zoom Computer Hardware, the LEVEL parameter of the PRE DRIVE, MAIN DRIVE, or EQ effect module might be set too low. To resolve this, activate Edit mode and adjust the parameter.
What to do if the connected amplifier's power is OFF for Zoom player 3000 Computer Hardware?
Ensure that the connected amplifier's power is turned ON to properly use your Zoom Computer Hardware.
Why is the FUNCTION switch on my Zoom Computer Hardware not working for delay time tap input or hold delay?
If the FUNCTION switch is not working for delay time tap input or hold delay on your Zoom Computer Hardware, check if the FUNCTION switch mode is set correctly. Set the FUNCTION switch mode to "3: DELAY (TAP&HOLD)".
What to do if Zoom player 3000 3000 is muted?
If your Zoom Computer Hardware 3000 is muted, and the FUNCTION switch mode is set to "MUTE", press the FUNCTION switch to turn off the mute condition.
What to do if the cut with the EQ effect module appropriately adjust the levels for each parameter setting too strong on Zoom player 3000 Computer Hardware?
To address overly strong cut levels with the EQ effect module on your Zoom Computer Hardware, enter the Edit mode and adjust the levels for each parameter.
How to turn up master volume on Zoom player 3000?
If the master volume is turned down on your Zoom Computer Hardware, turn the VALUE knob in Play mode to adjust the volume.
What to do if RP01 foot pedal cannot be used for RTM on Zoom player 3000?
Verify that the PEDAL-WAH or PEDAL-PITCH effect type is selected for EQ or EFFECT1 on your Zoom Computer Hardware.
General| Brand | Zoom |
|---|---|
| Model | player 3000 |
| Category | Computer Hardware |
| Language | English |
Overview of the top panel controls, buttons, and displays for the effect processor.
Identification of the input/output jacks and connectors on the rear panel.
Performing with the unit, selecting patches, and tuning.
Editing patch parameters and global settings.
Explanation of information shown on the display in Play mode.
Procedure for navigating between Edit and Play modes.
Procedure to assign one of seven modes to the FUNCTION switch.
