■
Parameter 1 TYPE (Effect Type)
The following six effect types can be selected for the
EFFECT2 module.
Type 1 PITCH (Pitch Shifter)
Type 2 HPS (Harmonized Pitch Shifter)
Type 3 CHO (Chorus)
Type 4 FLG (Flanger)
Type 5 TREM/PAN (Tremolo/Auto Panpot)
Type 6 RING MOD (Ring Modulator)
Depending on the selected effect type, the content of
parameters 2 - 5 changes.
■ Type 1 PITCH (Pitch Shifter)
Allows to shift the pitch over a range of 2 octaves up
or down.
●Parameter 2 Pitch
Determines the amount of pitch shift in semitones.
●Parameter 3 Fine
Allows fine-adjusting of pitch shift amount.
●Parameter 4 Shift
Determines the direction of pitch shift. "dn" means a
downward change and "UP" an upward change.
●Parameter 5 Bal (←RTM)
Determines the level balance between effect sound
and original sound. "0" means original sound only,
and "1.0" (100) means effect sound only.
■ Type 2 HPS (Harmonized Pitch Shifter)
Pitch shifter which creates harmonies using a preset
key and scale. By using this effect together with the
HPS of the EFFECT1 module, a three-part harmony
can be created. The parameter content is the same as
for HPS in the EFFECT1 module.
When using this effect type, you should play single
notes.
■ Type 3 CHO (Chorus)
This is a chorus effect which achieves an expansive,
warm sound.
●Parameter 2 Depth
Determines the depth of the effect.
●Parameter 3 Rate
Determines the modulation rate.
●Parameter 4 Mode
Determines the chorus effect variation.
M1,M2 = mono chorus variation
S1,S2 = stereo chorus variation
●Parameter 5 Mix (←RTM)
■ Type 4 FLG (Flanger)
This is a flanger effect which creates a surging jet
sound.
●Parameter 2 Depth
●Parameter 3 Rate (←RTM)
Determines the rate of the flanger effect.
●Parameter 4 Mode (PreDLY)
Determines the delay time of the flanger effect.
●Parameter 5 Peak (FB)
Adjusts the wave characteristic of the flanger effect.
Parameter 1
TYPE
1. PITCH 2. HPS 3. CHO 4. FLG 5. TREM/PAN 6. RING MOD
Parameter 2
Pitch Key Depth
0,1,2,・・・11,12,24 C,C#,・・・A#,b
0〜10
Depth(Time)
0〜10
Parameter 3
Fine Scale Rate Rate(←RTM)
−10〜oF〜+10
M3,m3,4t,5t,6t
1〜50 1〜50
Parameter 4
Shift Mode Mode Mode(DEPTH) Mode(Reso)
dn,UP
M1,M2,S1,S2
1〜10 0〜10 0〜10
Parameter 5
Bal(←RTM) Mix(←RTM) Peak(FB) Peak(CLIP) Mix
0〜99,1.0 0〜99,1.0 0〜10 0〜10 0〜99,1.0
Parameter 6
SERI/PARA(P)
Sr,P1〜P9
Parameter 7
EFFECT2RTM
−10〜+10