Zoom U-44 - Using Digital Audio Equipment (continued); Inputting an S;PDIF Signal

20
Inputting an S/PDIF signal
1. Switch to OPTICAL or COAXIAL to select
the input you want to use.
2. Connect the S/PDIF device to the S/PDIF IN jack set in step 1.
S/PDIF OUT jack
S/PDIF IN jack S/PDIF IN jack
S/PDIF device
(output)
(input)
NOTE
t 8IFOBNJDDBQTVMFJTDPOOFDUFEUPUIF.*$*/DPOOFDUPSUIF41%*'JOQVUTBSFEJTBCMFE
t 5IF41%*'JOQVUTBSFBTTJHOFEUP*/165
3. Confirm synchronization has occurred by
checking that the SYNC indicator is lit.
NOTE
t 5PTZODISPOJ[FBVEJPDMPDLUIF and the connected device must have the same sampling rate settings.
t 5IF 4:/$JOEJDBUPSXJMM CMJOLXIFO B EJHJUBM BVEJPEFWJDFJT DPOOFDUFEUP B 41%*'*/ 015*$"-PS $0"9*"-CVU
synchronization with the digital audio device is not possible. In this case, the will operate using its internal clock.
$IFDLUIF41%*'*/4&-&$5TXJUDITFUUJOH
6TJOH%JHJUBM"VEJP&RVJQNFOU(continued)