zortrax M200 - First Use Preparations; Unboxing and Initial Printer Removal

©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
19
First Use Preparations
1. Open the box and remove the cushioning material.
2. Take the 3D printer out of the box*.
When lifting or moving the printer, do not grab:
a. belts,
b. shipping clips,
c. extruder.
* Bearing in mind the printer’s weight (30kg/66lbs), Zortrax M300 should be taken out of the box or moved by two people.