©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
31
Platform Calibration
19. Platform calibration is a procedure of checking the distance between the nozzle and ve points
on the platform, and tightening/loosening the calibration screws.
From the main menu select “Maintenance” and then “Autocalibration.” At this point the printer will
start to heat up the extruder.
WARNING! The extruder will be hot during the autocalibration. Don’t touch it. Wear safety
gloves.
To Next Page
