ZOTAC ZBOX nano
14
4. Connecting to USB 2.0 devices
Connect USB 2.0 devices such as keyboards, mice, cameras and hard disk drives.
5. Connecting to an HDMI display
Connect one end of an HDMI cable to an HDTV or monitor, and the other end to the HDMI
port on the system rear panel.
6. Connecting a DisplayPort display
Connect the DisplayPort connector to the DP port of the monitor or display.
7. Connecting a VGA display
Connect the VGA connector to the VGA port.
8. Connecting the power adapter and turning on the ZBOX nano
Connect the supplied AC adapter to the DC IN jack on the system rear panel and then press
the power switch on the front panel to turn on the system.
When your ZOTAC ZBOX nano is not in use, unplug the power adapter or switch off the AC
outlet to conserve power.
To Next Page
Loading...
Need help?
General
