1-16 • 02418V10 • 11.08.2016/DC
Winding process
• Press the switch JOGGING, until the
empty bobbin starts fi lling.
• Close the winder cover.
• Operate the dip-switch on front side in
position ON.
Check once in a while the charging level of the bobbin depot
during the automatic winding process. Fill the depot with more
empty bobbins if needed.
The automatic winding process begins. The thread will be cut after fi lling the fi rst
bobbin, another bobbin will be loaded and fi lled.
This process is continued until it will be interrupted.
• Operate the dip-switch on front side in position OFF.
To Next Page
Loading...