10
Do not attempt to disassemble your
phone.
Only use approved accessories.
For pluggable equipment, the
socket-outlet shall be installed near the
equipment and shall be easily accessible.
Don’t rely on your phone as a primary
device for emergency communications.
FCC RF Exposure Information (SAR)
This phone is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the United
States.
During SAR testing, this device was set to
transmit at its highest certified power level in all
tested frequency bands, and placed in positions
that simulate RF exposure in usage against the
head with no separation, and near the body with
the separation of 10 mm. Although the SAR is
determined at the highest certified power level,
the actual SAR level of the device while operating
can be well below the maximum value. This is
because the phone is designed to operate at
multiple power levels so as to use only the power
required to reach the network. In general, the
closer you are to a wireless base station antenna,
the lower the power output.
The exposure standard for wireless devices
employing a unit of measurement is known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg.
This device is complied with SAR for general
population/uncontrolled exposure limits in
To Next Page
Loading...
Need help?
General
