Zte MF58 - Page 45

ZTE MF58
44
A: Please, check the color of the signal indicator. If the signal indicator is not lightened, the
mobile camera has not powered on normally. Please press Power key to power on the
mobile camera. If the signal indicator is red (flash), there is no 3G network available or the
signal of the 3G network is very weak. If the signal indicator is yellow (flash), the mobile
camera is not work properly. If you cannot make a video call, make sure you are not
roaming and/or not using the CLIR function. Unidentified numbers (using the CLIR function)
cannot access the mobile camera due to safety reasons.
Q: Why is the communication unstable and I cannot make a video call at some
places?
A: The communication may be unstable or the video call may not be established when
you are at places where the signal is too weak. Please, move to a different place and try
again or contact your service provider.
Q: Why isn’t there any notifying tone when establishing a video call?
A: It depends on the settings of the mobile camera. You can set the switch of the notifying
tone on/off by sending an SMS command through the administrator’s (AD) number.
Q: Why is there echo when using the mobile camera at some places?
This Manual: http://www.manuallib.com/file/2593400