Zte MF928 - Advanced Settings

13
Advanced Settings
This chapter provides information on how to configure advanced settings for
your MF928, such as Wi-Fi network options, WAN and router settings, and
more.
Select Settings > Wi-Fi Settings > Advanced Settings. The Advanced
Settings configuration is shown in the following figure:
 Band Selection – Select the Wi-Fi band range used for your network(s).
The 2.4 GHz band uses less power and has a longer range than the 5
GHz band, but the 5 GHz band can provide higher speeds with less
interference.
 Network Mode – Select the WLAN protocol. The recommended mode
depends on the Wi-Fi band. When using the 2.4 GHz band, select
802.11 b/g/n. When using the 5 GHz band, select 802.11 a/n/ac.
 Channel Bandwidth – Select a bandwidth option, if necessary (not
recommended without prior experience). When using the 2.4 GHz band,
select 20MHz or 20MHz/40MHz; when using the 5 GHz band, select 20
MHz, 20 MHz/40 MHz, or 20 MHz/40 MHz/80 MHz.
 Country/Region Code – Select the country in which your device is
located.
 Frequency (Channel) – Select the frequency (channel) for your Wi-Fi
network(s). The recommended option is Automatic, which will select the
channel with the least potential interference.