29
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Troubleshooting
Problem
Suggested Solution
CannotestablishtheWi-Ficonnectio
nbetweentheMF928deviceandyou
rWi-Fienableddevice.
Make sure the Wi-Fi function is active.
Refresh network list and select the
correct
SSID.
Check the IP address to make sure your device
can obtain an IP address automatically in the
Internet
protocol
(TCP/
IP
) properties.
Type the correct network key (Wi-Fi password)
when you
connect
to the MF928 device.
Your connected device cannot
access the Internet.
Make sure
your nano-SI
Mcard is
installed
.
Change the
location
to find a place with a good
signal.
Make sure the APN is correct. Contact
you
service provider to obtain the APN and add i
manually.
Cannot access the web
configuration page.
Enter the correct
address
. The default address
is
http://192.168.1.1
.
Only use
one
network adapter in your PC.
Do not
use
any proxy
server
.
To Next Page
Loading...
