Page 8 of 38
Blue solid
Registered on the 4G network
Blue blinking
Active data transfer on the 4G network
During periods of inactivity it is normal for the LED’s to go out to preserve battery
life. Press the power key briefly to confirm the device status if required.
The battery light will flash periodically to indicate the device is On.
* RED NETWORK LED, OFFLINE, NOT REGISTERED ON
THE NETWORK
No Network Access can be any of the following conditions:
• A missing, faulty or incorrectly inserted SIM. Check you have inserted your SIM
card the right way and fully pushed it home into place.
• A Non-Telstra SIM card. This device is Network Locked to Telstra, contact Telstra
to unlock your device.
• A PIN locked SIM card. Log into the web interface then enter the PIN code for
your SIM card.
• A PUK locked SIM card. You may have entered the wrong PIN code too many
times. Contact Telstra to obtain your PIN Unlocking Key (PUK) code. Log into the
web interface to enter your PUK and PIN code
• A PUK blocked SIM card. If you enter the wrong PUK code too many times the
SIM card is permanently blocked. Contact your dealer to obtain a replacement
SIM card.
• No Service, you are out of network coverage.
CONNECT DEVICES BY WI-FI
Your Wi-Fi hotspot can connect up to ten devices via Wi-Fi providing internet
access for all your devices on the go.
• On the devices you wish to connect make sure Wi-Fi is switched on, then search
for Wi-Fi devices.
• The Wi-Fi hotspot will show up as TPW4G_xxxxxx, click on this device to
connect.
• Consult your device security card, or make a note of your Password from the
sticker in the battery compartment.
• Enter the default Password which is case sensitive. Any letters entered must
be
in upper case (capitals).
To Next Page
Loading...
