21
Troubleshooting
Symptoms Possible Problems/ Solutions
There is no dial tone.
Please wait for 1~2 minutes
after the WF723CA is turned
on.
If signal reception is poor,
move to where signal reception
is good.
The connection sounds
disorted/noisy.
Remove any electrical
appliance which is too close to
the phone or WF723CA.
The cable or phone set might
be damaged. Try using a
different cable or phone, or
contact the dealer.
There is a rapid engaged tone
when the phone is removed from
the receiver.
Place the phone back on the
receiver and try again.
After dialing, there is no tone.
After dialing, wait 4~8 seconds
for the call to connect.
To Next Page
Loading...
