Zte ZXHN H267N - Device Interfaces and Buttons

Figure 2-1 Cable Connection

Table 3-1 describes the interfaces and buttons on the back panel and side
panel of the ZXHN H267N device.
Table 3-1 Interfaces and Buttons

Interface/Button
Description
ON/OFF
Power switch
Power 12 V DC power connector
Phone1/Phone2
RJ-11 telephone interface, connected to the telephone
with RJ-11 telephone cable.
LAN1/LAN2/LAN3 RJ-45 FE Ethernet interface
LAN4/WAN
RJ-45 GE Ethernet interface, WAN interface is
optional.
DSL RJ-11 DSL interface

Reset
Reset button
When the power is on, use a needle to press the button
for over 5 seconds to restore the default settings.
WLAN
WLAN button
Enable/disable the WLAN function.

WPS
WPS button
Enable/disable the Wi-Fi protection. When the Wi-Fi
protection is enabled, users can access the network
automatically.
USB USB 2.0 interface
• The USB interface is on a side of the ZXHN H267N.
4 Indicator