Chapter 4 Wizard
Enable UPnP: Enables/disables the UPnP function. The
default is disabled.
WAN connection: Selects the WAN side connection
LAN connection: Selects the LAN side connection
4.7.3 DMZ
When the device operates in Routing mode, if you try to access a service
on a host placed in the intranet from an external network, the DMZ host
function should be enabled.
Click the Advanced Configuration button on the main page, and then
DMZ on the left side of the page to enter the DMZ configuration page.
Select the LAN host IP address to be accessed from the WAL side. Check
the Enable DMZ check box to enable this function.
27
To Next Page
Loading...
