Need help?Do you have a question about the Zünd L-3200 and is the answer not in the manual?
General| Cutting Width/Working Area | 3200 mm |
|---|---|
| Cutting Speed | Up to 100 m/min |
| Maximum Material Thickness | 50 mm |
| Control System | Zünd Cut Center |
| Software | Zünd Cut Center |
| Power Requirements | 400V, 50/60 Hz |
| Air Pressure | 6 bar |
| Dimensions | Varies depending on configuration |
Emphasizes the importance of safe operation and correct usage.
Explanation of hazard symbols, signal words, and warning structures.
Guidelines for safe work practices and actions during malfunctions.
Details on general danger areas, module carriage, and installation danger zones.
Guidelines for work/traffic areas and the importance of safety signs.
Description of protective systems, operating units, and emergency stops.
Requirements for PPE and information on mechanical hazards.
Safety measures for fire, laser hazards, and general operator safety.
Overview of controls and essential safe working practices.
Detailed description of the control panel, operating unit, and keys.
Guidance on navigating menus, functions, user levels, and key settings.
Detailed listing of error codes, causes, and solutions.
Detailed procedures for cleaning guide rails, bearings, and other components.
To Next Page
