Need help?Do you have a question about the Zünd XL-1600 and is the answer not in the manual?
General| Cutting Width | 1600 mm |
|---|---|
| Cutting Speed | Up to 100 m/min |
| Modular Tooling | Yes |
| Frequency | 50/60 Hz |
| Control System | Zünd Cut Center |
| Voltage | 400 V |
Specifications including dimensions, electrical, and performance data.
Explanation of safety symbols, signal words, and hazard warning structure.
Identification and description of hazardous zones on the cutter.
Information on protective systems and emergency stop functions.
Required safety gear for operators and service personnel.
Guidelines for safe operation to prevent injury and damage.
How to navigate through the cutter's menu structure and functions.
Procedures for daily checks, start-up, and operating statuses.
Comprehensive list of error codes, causes, and solutions.
To Next Page
