9. Now unplug the camera and plug another camera on, and do the same routine to other camera and
NVR.!
Step 3: Change the PC setting back once all camera and NVR is configured
Now you need to change the PC back to normal setting, if you don’t do this, your PC may not be able to
access internet again.!
1. Go to Control Panel > Network and Internet > Network Connection!
2. Right click on Local Area Connection, on the drop down, click on Properties!
3. On the newly opened window, Click on the Internet Protocol Version 4 (TCP/IPv4)!
4. Change the setting to following:!
1. Click on Obtain an IP address automatically!
2. Click on Obtain DNS server address automatically!
5. Now Click on OK and OK!
Step 4: Configure your Camera or NVR one at a time
1. Once you have finished all the setup above, follow Chapter 6 to plug all equipment together.!
To Next Page
Loading...