4. If the DHCP is tick, you need to uptick.!
5. Change Subnet Mask, Default Gateway and DNS to the same figure you find on Step 1, but IP
address you need to change the last digital to avoid conflict, for example, if your Step 1’s ip address is
192.168.1.2, you need to change it to 192.168.1.5 or anything else).!
6. Put in the password. Refer to chapter for credentials.!
7. Click on modify.!
8. If you have a “Password error”, it doesn’t necessarily mean password is wrong, it could mean you have
done Step 3 incorrectly.!
9. If now error message comes up, click on search again, now the detail should be changed.!
Step 5: Repeat for Each IP Camera
Now you need to plug in another camera and repeat from Step 1 to Step 5. Make sure the IP address you
change in Step 4 should always be different for each device.!
Step 6: Change the Network Setting for Your NVR
1. You need to do this on a TV monitor that you have connected your NVR to.!
2. Click on Main Menu > Sys Setup > Network!
3. Untick DHCP if it is ticked!
4. Change Subnet Mask and Default Gateway to the same figure you find on Step 1, but IP address you
need to change the last digital to avoid conflict, for example, if your Step 1’s ip address is 192.168.1.2,
you need to change it to 192.168.1.10 or anything else).!
5. Change the DNS and DNS 2 should be exactly the same as gateway.
6. Leave others to be the same.!
7. Click on Save!
Step 7: Change Computer to Original Setting
1. Once you have done all configurations for all devices, you need to go back to your PC and go to
Control Panel > Network and Internet > Network Connections. !
2. Right click on the connection, click on property, and click on the Internet Protocol Version 4.!
3. This time you need to select Obtain an IP address automatically and Obtain DNS server address
automatically. And click on OK and OK.!
4. This step is important as it puts your PC back to normal network.!
Step 8: Putting Things Together
•
Connect all equipment all according to Chapter 6!
•
Go to Main Menu > Remote Device of your NVR!
•
Click on search, all your camera should come up on the search result.!
•
If you have more than 1 camera, the ip should all look different, if they are the same You have done Step
5 correctly.!
•
Click on Add. !
•
Click on confirm.!
•
Hopefully by now, live image should come on to your monitor.$
To Next Page
Loading...