ES-3100 Series Switch Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
100
VLAN Configuration via EMS
In this section, we will give an example to illustrate how to use EMS to create a
VLAN2 in GS-4024. Here are the procedures.
Step 1: In the device panel list shown in Figure 12, right-click Configuration,
Switch Configuration and then Switch Setup tab as shown in Figure 12 and
Figure 13.
Step 2: Define the VLAN type, there are two types of VLAN, one is 802.1Q and
the other is Port-based VLAN. Select 802.1Q as the VLAN type and click
Apply in the Figure 14.
Figure 12 Device panel list
Figure 13 Switch Configuration
To Next Page
Loading...
