What to do if the LNK/ACT LED on my ZyXEL Communications Dimension GS-2024 Switch doesn't light up?
If the LNK/ACT LED on your ZyXEL Communications Switch does not light up or flash when a device is connected, ensure that the connected device is powered on and properly connected to the switch. Also, check that the Ethernet cards on the connected devices are functioning correctly and that the network cable is not longer than 100 meters.
Why are none of the LEDs on my ZyXEL Communications Dimension GS-2024 Switch lighting up?
If none of the LEDs on your ZyXEL Communications Switch are lighting up when the power is connected, verify that the included power adapter or cable is correctly connected to both the switch's power receptacle and a suitable power source. If the problem continues, it may indicate a hardware issue, and you should contact your vendor.
Why can't I access the web configurator on my ZyXEL Communications Dimension GS-2024?
There might be several reasons why you cannot access the web configurator. First, ensure you've enabled web service access. Also, confirm that your computer's IP address matches the secured client IP address if you've configured one, and that your computer and the Switch are on the same subnet. The default administrator username is 'admin', and the default password is '1234', both case-sensitive. If you've forgotten a changed password, you'll need to upload the default configuration file to restore factory defaults, including the password.
How to fix Telnet access on ZyXEL Communications Dimension GS-2024 Switch?
If you're having trouble accessing the Switch using Telnet, first ensure the ports are properly connected. You might have exceeded the maximum number of concurrent Telnet sessions, so close any other Telnet sessions or try connecting again later. Also, verify that you've enabled Telnet service access. Finally, if you've configured a secured client IP address, your computer’s IP address must match it.
What to do if the ZyXEL Communications Dimension GS-2024 LEDs don't turn on?
If none of the LEDs turn on when you power on the Switch, check the power connection and ensure the power source is turned on. If the problem continues, it could be a hardware issue, and you should contact your vendor.
General| Switching Capacity | 48 Gbps |
|---|---|
| MAC Address Table | 8K |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Forwarding Rate | 35.7 Mpps |
| Jumbo Frame Support | 9 KB |
| Switch Type | Managed |
| Ports | 24 x 10/100/1000BASE-T |
| Standards | IEEE 802.3, 802.3u, 802.3ab, 802.3x |
| Operating Temperature | 0°C to 50°C |
| Humidity | 10% to 90% (non-condensing) |
To Next Page
