ES-2000 Series Switch Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
40
Configuring your Switch to fulfill this scenario (CLI)
1. Connect the Switch Console port with your PC or Notebook.
2. Open your Terminal program.(Ex, Hyper Terminal in Windows
System)
3. Make sure that your port settings are
bps:9600
Data bits:8
Parity: None
Stop bits:1
Flow control: None:
4. After you connected successfully, give the correct user name and
password.
5. Put “en” or “enable” to go into the privileged mode. Then put “config” to
go into the configuration mode.
6. Put the following commands to setup Port Based VLAN on your Switch
in this
To Next Page
Loading...
