Chapter 3 Status
FMG Series User’s Guide
21
Each field is described in the following table.
3.3 Fiber Status
Use this screen to view the status of the FMG. Click Status > Fiber to open this screen.
Figure 12 Fiber Status Screen
Table 8 Device Status Screen
LABEL DESCRIPTION
System
Model Name This shows the model number of your FMG.
Uptime This field displays how long the FMG has been running since it last started up. The FMG starts
up when you plug it in, when you restart it (Maintenance > Reboot), or when you reset it.
Firmware
Version
This is the current version of the firmware inside the FMG.
CPU Usage This field displays what percentage of the FMG’s processing ability is currently used. When
this percentage is close to 100%, the FMG is running at full load, and the throughput is not
going to improve anymore. If you want some applications to have more throughput, you
should turn off other applications.
Memory Usage This field displays what percentage of the FMG’s memory is currently used. Usually, this
percentage should not increase much. If memory usage does get close to 100%, the FMG is
probably becoming unstable, and you should restart the device. See Section 8.2 on page
39, or turn off the device (unplug the power) for a few seconds.
IP Configuration
IP Address This is the current IP address of the FMG in the LAN/WAN.
If the FMG has a fiber connection, this field will show the WAN IP address.
IP Subnet Mask This is the current subnet mask in the LAN.
MAC Address This shows the LAN Ethernet adapter MAC (Media Access Control) Address of your FMG.
LAN/WAN Port Status
LAN This column displays each interface the FMG has.
Status This field indicates the interface’s use status.
This field displays Up when using the interface and Down when not using the interface.
Speed This displays the port speed and duplex setting.
Refresh Click this to update the information in this screen.
To Next Page
Loading...
