Chapter 8 Backup Restore
FMG Series User’s Guide
40
Restore Configuration
Restore configuration allows you to upload a new or previously saved configuration file from your
computer to your FMG.
Do not turn off the FMG while configuration file upload is in progress.
After the FMG configuration has been restored successfully, the login screen appears. Login again to
restart the FMG.
The FMG automatically restarts in this time causing a temporary network disconnect. In some operating
systems, you may see the following icon on your desktop.
Figure 21 Network Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default device IP address (192.168.1.1).
Reset Configuration
Click the Reset button to clear all user-entered configuration information and return the FMG to its
factory defaults. The following warning screen appears.
Figure 22 Reset Warning Message
Figure 23 Reset In Process Message
You can also press the RESET button on the rear panel to reset your FMG to the factory default mode.
Refer to Section 1.4.2.2 on page 13 for more information on the RESET button.
Table 18 Restore Configuration
LABEL DESCRIPTION
Choose File Click this to find the file you want to upload. Remember that you must decompress compressed
(.ZIP) files before you can upload them.
Restore Click this to begin the upload process.
To Next Page
Loading...
